BYVKW - 9SF WHITE OPAQUE CLEAR PRINT STAMP PAD (SUPDAT)
- MSDS: BYVKW
- Manufacturer: PATERSON STAMP WORKS
- Product Name: 9SF WHITE OPAQUE CLEAR PRINT STAMP PAD (SUPDAT)
- National Stock Number: 7510-00N062996
Product Identification
Product ID:9SF WHITE OPAQUE CLEAR PRINT STAMP PAD (SUPDAT)
MSDS Date:04/15/1985
FSC:7510
NIIN:00N062996
MSDS Number: BYVKW
Responsible Party
CLIFTON, NJ 07015
NJ
Emergency Phone: 201-478-5600
Info Phone: 201-478-5600
Cage: 23250
Contractor
Telephone: 201-478-5600
Cage: 23250
Ingredients
2-PENTANONE, 4-HYDROXY, 4-METHYL-, (DIACETONE ALCOHOL)
CAS: 123-42-2
RTECS: SA9100000
Fraction By Weight: 51.64%
OSHA PEL 50 PPM
ACGIH TLV: 50 PPM
RESINS
Fraction By Weight: 19.75%
OSHA PEL N/K
ACGIH TLV: N/K
PIGMENTS
Fraction By Weight: 27.35%
OSHA PEL N/K
ACGIH TLV: N/K
SALICYLANILIDE
CAS: 87-17-2
RTECS: VN7850000
Fraction By Weight: 1.26%
OSHA PEL N/K
ACGIH TLV: N/K
MAY BE TAKEN UP ON SAND, CLAY, EARTH, FLOOR
RTECS: 9999999ZZ
AND FEDERAL REGULATIONS.
RTECS: 9999999ZZ
SUPPLIER). ENGINEERING/ADMINISTRATIVE CONTROLS
RTECS: 9999999ZZ
LENGTH FACESHIELD .
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:CAN CAUSE SEVERE
IRRITATION, REDNESS, TEARING, BLURRED VISION. SKIN:PROLONGED OR
REPEATED CONTACT CAN CAUSE MODERATE IRRITATION, DEFATTING,
DERMATITIS. INHALATION:EXCESSIVE INHALATION OF VA PORS CAN CAUSE
NASAL AND RESPIRATORY IRRITATION, DIZZINESS, WEAKNESS, FATIGUE,
NAUSEA, HEADACHE, POSS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:UNCONSCIOUSNESS, AND EVEN
ASPHYXIATION. INGESTION:CAN CAUSE GASTROINTESTINAL IRRITATION,
NAUSEA, VOMITING, DIARRHEA.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:SKIN:THORO WASH EXPOS AREA W/SOAP & WATER. REMOVE CONTAMD
CLTHG. LAUNDER CONTAMD CLTHG BEFORE REUSE. EYES:FLUSH W/LG AMTS OF
WATER FOR @ LEAST 15 MINS, LIFTING UPPER & LOWER LIDS OCCASNLY, GET
MED ATT N. INGEST:GIVE 2 GLASSES OF WATER, INDUCE VOMIT IMMED BY
STICKING FINGER DOWN THROAT. CALL PHYS. NEVER GIVE ANYTHING BY
MOUTH TO UNCON PERSON. INHAL:REMOVE INDIVIDUAL TO FRESH AIR. IF
BRTHG (SUPDAT)
Fire Fighting
Flash Point Method:TOC
Flash Point:170F,77C
Lower Limits:1.8%
Upper Limits:6.9%
Extinguishing Media:ALCOHOL FOAM, FOAM, CARBON DIOXIDE, AND DRY
CHEMICAL.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:VAPS ARE HVR/AIR & MAY TRAVEL ALONG
GROUND/BE MOVED BY VENT & IGNITED BY HEAT, PILOT LIGHTS, OTHER
FLAMES & IGNIT SOURCES AT LOCATIONS FROM MATL HNDLG POINT.
Accidental Release
Spill Release Procedures:SM SPILL:ABSORB LIQ ON PAPER, VERMICULITE,
FLOOR ABSORB/OTHER ABSORB MATL & TRANSFER TO HOOD. LG SPILL:ELIM
ALL IGNIT SOURCES (FLARES, FLAMES INCLDG PILOT LIGHTS, ELEC SPK).
PERSONS NOT WEARING PROT E QUIP SHOULD BE EXCLUDED FROM AREA OF
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:CNTNRS OF MATL MAY BE HAZ WHEN
EMPTIED, SINCE EMPTIED CNTNRS RETAIN PROD RESIDUES (VAP, LIQ, &
SOLID), ALL HAZARD PREC GIVEN IN MSDS MUST BE OBSERVED.
Other Precautions:OVEREXPOSURE TO COMPONENTS HAS APPARENTLY BEEN FOUND
TO CAUSE FOLLOWING EFTS IN LABORATORY ANIMALS; ANEMIA, LIVER
ABNORMALITIES, KIDNEY DAMAGE.
Exposure Controls
Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED,
NIOSH/MSHA JOINTLY APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE
OF PROPER ENVIRON CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH/MSHA
RESPS UNDER SPECIFIED CNDT NS. (SEE YOUR SFTY EQUIP (ING 7)
Ventilation:PROVIDE ENOUGH MECHANICAL (GENERAL & LOCAL EXHAUST) VENT TO
MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:BUTYL RUBBER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORK GOGG & FULL(ING 8)
Other Protective Equipment:IMPERVIOUS CLOTHING & BOOTS. ANSI APPRVD
EMERGENCY EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR TRADE NAME/PART NO:INK (9 WHITE SF). FIRST AID PROC:IS DFCLT, ADMIN
OXYG. IF BRTHG HAS STOPPED GIVE ARTF RESP. KEEP PERSON WARM, QUIET
& GET MED ATTN. SPILL RELEASE:SPILL UNTIL CLEAN-UP HAS BEEN C
OMPLETED. STOP SPILL AT SOURCE, DIKE AREA OF SPILL TO PVNT
SPREADING, PUMP LIQ TO SALVAGE TANK. REMAINING LIQ (ING 5)
Chemical Properties
Boiling Pt:B.P. Text:337F,169C
Vapor Pres:0.8 @ 20C
Vapor Density:4.0
Evaporation Rate & Reference:0.14 (N-BUTYL ACETATE=1)
Solubility in Water:51.64% BY WEIGHT
Appearance and Odor:WHITE LIQUID, FAINT PLEASANT ODOR.
Percent Volatiles by Volume:51.64
Stability
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH; STRONG OXIDIZING AGENTS, STRONG ALKALIS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.
Disposal
Waste Disposal Methods:SM SPILL:ALLOW VOLAT PORTION TO EVAP IN HOOD.
ALLOW ENOUGH TIME FOR VAPS TO COMPLETELY CLEAR HOOD DUCT WORK.
DISPOSE OF REMAINING MATL BY APPLIC REGS. LG SPILL:DESTROY BY LIQ
INCIN. CONTAMD ABSORB MAY BE DEPOSITED IN LANDFILL BY LOCAL, STATE
(ING 6)
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.